There is a coating arborists use after pruning or trimming, I've used that for the same purpose, maybe that would suffice, was also thinking of a handful of mortar, packed in just so, probably best to do some research first. Black cherry and other trees that I have seen will put up with an unbelievable amount of damage and still live, though some black cherry trees, on the mature side, I have taken down as it would not be long anyway. They can be almost fully girdled by something and still have a healthy top, I have dead ones where the water line came up from beaver, it was marsh, now a pond, bark off, and they have been there standing dead for like 30 years, that's better than treated lumber, as they are in standing water. I find it interesting to be selective when harvesting trees, as I have seen this place become forest over the years, most if not all was fields, pasture or the farm house and barn areas, I've taken down trees 20" at the butt in those places, mostly elm that just died. Those carpenter ants are something, those we have in abundance, they spread easily, I have had sub colonies in small chunks of wood. Whenever I see trees damaged by them I'll either try to remedy the situation or cut them down, to protect the healthy ones. There is enough standing dead elm for them, and the woodpeckers anyway. That pileated woodpecker is something else, fearless of me, I can walk right up to the one that has been here, took some shots and video early last summer, late spring as he flung off bark and rotted wood right onto me LOL !
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
