Posted by michiganmike on April 06, 2015 at 20:06:47 from (64.136.26.151):
I've been too busy to cut some black locust. I always cut in the winter so the sap is down, sapped post don't last like unsapped post do. I want to cut some, BL at least get them off the stump. I want to have some milled for floor decking on 2 trailers. I've got some white oak, but not enough of them to sacrifice any for this. Mainly I want to floor a tandem dully trailer . I have a skylift that punched holes in my buddies trailer, when we took it off of his trailer. He wanted to use it to set trusses for a barn. His flooring was PT pine, same as mine. his cross members are spanned further than mine. I just don't want any problems like that with my trailer. He ended up having an oak floor milled for his. I told him make sure he gets white oak. My cross members are on 16" his are 24".any one know how the BL and WO compare tinsel speaking? I was going to have them milled at 2". I live in SE MI. thanks MTP...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
