Posted by Bryce Frazier on April 17, 2015 at 15:44:10 from (67.142.182.22):
Title says it all, man, I kicked it to the curb today! :)
Left at 6, had the H on the trailer and ready to come home at 9, made it home at 12, unloaded.
The H:
Has lots of good parts! Sheet metal, fuel tank, and most of the other stuff that is off of it in the picture came with it (was just sitting there in a pile) WFE has NO cracks/welds of anysort on it. Left rear tire is useable, 12.4 x 38, %60, right rear, BRAND NEW Armstrong 12.4 x 38 %99!!! Can't believe it! What a good surprise! :) Also has a metal belt pulley, rather than those cloth ones. Few other nice perks about it too....
After getting home and unloading, I had both trucks and trailers ready to be loaded up to go to plow day. I am taking:
1954 John Deere 40 T 2 way 1x16 Case Plow 2x14 Case Plow 1952 Super C 8 foot Oliver Disc
Got both trailers all loaded up, and there was mom waiting for a picture! So, here ya go... A picture of a true woods boy! :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
