Posted by LAA on April 20, 2015 at 07:20:27 from (217.175.64.196):
In Reply to: Running A Stackwagon? posted by Bryce Frazier on April 20, 2015 at 06:49:38:
You will pick it up quickly because you already understand about handling equipment on uneven ground and paying attention to what your machine is telling you. When I worked on Kansas baling crews years ago the stack wagon operator would let the balers get a round or two head start then go in the opposite direction, this kept him out of the dust and he could see what he was doing a lot better and did not have to worry about getting in the balers way. One word of advice, anytime your offered a job do not show hesitation, if you don't want the job thank them and refuse but if you want or need the job tell them you will be Johnny on the spot and then go learn all you can about the operation and what is required of the position you will have. Many a person has lost out on good opportunities because the would be employer saw that they did not have confidence in themselves, you don't have to exaggerate your skills or lie, just be positive and make sure they know you work at anything undertaken until you succeed. As far as stress goes, that is mostly self imposed and in people's minds, if you know what you are doing and have confidence in your own ability you will never know stress at work. The majority of people do not pay attention to what is going on around them much less to what they are doing themselves, the few that do are the leaders on every job regardless of age or relative experience level. There ought to be beaucoup YouTube videos of people running stack wagons to get a start. Good luck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
