Posted by 2510Paul on April 28, 2015 at 07:15:44 from (173.202.142.245):
Responding to one of the comments in my rollover plow post earlier, yes the 4320 can pull a lot more. It just plays with the 3 x 18's although on a steep hill with clay it works it. I also have a problem rolling over the clay uphill on the steeper slops but I will save that for another post.
My issue is the 4320 really struggles to lift it. My son upped the pressure to the upper end of the spec. at the front pump but it did not make a difference. I have oil leaks at both the differential lock valve and the brakes. I have been looking at the 4020 service manual ( I don't have the 4320 service manual.) and it looks like there are many possible causes. One includes leakages at the brakes. I will have to redo the differential lock valve and brakes and then see if I have better results.
Right now I can just get it high enough to rotate the plow at the end of the furrow. Sometimes the coulter scrapes the ground. It's interesting, if I travel with the plow up for some distance it finally reaches something closer to full height. I believe the bouncing temporarily relieves the weight/pressure and each time it raises it a little more.
Anyway, I just thought I would put this out there and see if anyone had any other solutions for this that were common or "Check this first" items.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.