Posted by rrlund on May 07, 2015 at 15:59:02 from (162.250.27.207):
I think I'd get more field work done if I had a 40 hour a week job instead of cattle. There was a cow looking rough this morning. I called the vet just after 8. I changed the shovels on the chisel plow and a few other odds and ends until she got here at 11. Had quite a time with the cow,that's a whole 'nuther story,but the vet said no fever,but you'd do best to just load her up and get her out of here ASAP. It's rail cow Thursday,so we had her in the trailer by noon and headed for the stockyard. Got home a little after two,got to the field just before 2:30. Chisel plowed until just before 5:30. Went out to check cattle after supper,a new calf to tag,a board knocked off a fence,I'm supplementing two calves from heifers with a bottle a little bit until I get them on good pasture so they come up on their milk. Got them fed,it's almost 7,I quit. Tomorrow's another day I guess.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
