One action that hasn't been publicized nearly as much as it should have been is how destroyers saved the day during the Normandy invasion.
When the German shore emplacements pinned the attacking forces down on the beach, a half dozen destroyers came in almost like a cavalry charge, pulled in parallel to the beach, and began pounding the German emplacements at almost point blank range. Some of the destroyers guns got so hot from constant firing that fire hoses were pouring water on them while they were firing.
With no communication, some of the destroyer's gun crews were using tanks as spotters, reasoning that anything a tank was firing at was something they should be firing at, with more fire power than the tank possessed. The tank crews caught on to the fact that immediately after they fired at a target a destroyer fired at the same target and began working with the destroyers. The destroyers decimated the German defenses and turned the tide of the invasion.
Miraculously, no destroyers suffered serious damage. As one destroyer Captain later said, "I didn't give a damn what I did to my ship as long as I could help the guys on the beach".
It would appear there are still many untold stories from WWII.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
