Well I am home. Got the area he wanted done, big part of the job was to clear out roots from some type of brush that was in some of the areas....very tough roots. I can rip out 6" pine stumps easier than some of these. Anyway, typical, I get there, gate is locked, nobody answers the phone. I lay on the horn twice in 10 minutes then the wife finally comes out and says they overslept...I was 2 minutes away from leaving. So, everything goes good from there on...get signed in, get my ID badge...dirt turns out to be pretty soft so I do get down 20-24". Dusty and dirty work. This is a retired Californian, obvious long time grower, so I didn't try to tell him 24" was not necessary. So they are happy, said it was the first contractor that did what he said he would do....also want me back to do the rest and pop out some holes with the 2' auger. I did get paid :D
Went over to my mowing job looking to put in 4 hours there, but I had a front tire go flat at 2 1/2 hrs...and the spare in the truck was flat! Oh well, short day, only 12 1/2 hours....
Thanks for all the comments...I was sure this would have been poofed by the time I got home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
