Posted by picassomcp on May 13, 2015 at 17:35:13 from (50.107.39.94):
I have recently bought a used Hardi pull type sprayer. 300 Gal tank, 30 foot boom. It has a hydraulic roller pump on it now, not sure if that is a good thing or bad (I'm thinking bad as I'm not sure my old tractors have the hydraulic capacity to run it) The nozzles on the sprayer are incomplete, local teejet dealer didn't even recognize the brand of nozzle currently on it, either could the Hardi dealer. I'll likely change out the nozzles to teejets, I can do this for about $200. My question is about nozzle spacing. I see most sprayers have 20" nozzle spacing for 30" rows. This allows much overlap which I understand is exactly what you want. I drilled my beans in 14" rows this year. Could 20" nozzle spacing work with 14" rows?? Other uses for the sprayer will be hayfield burndown, and I may also try spraying a foliar fertilizer on some hayfields just to experiment a bit. In future years, I'll likely use a planter with 30" rows for my soybeans or any other row crops.
Also, with 14" rows, that doesn't leave much room to get a tire through the row when it comes time to spray. I'm thinking about using my Farmall C to spray with as it has 10" rear tires, all my other tractors have 15" tires or wider. Does the C even have a chance at running a hydraulic pump on this sprayer? Is 2" clearance between the tire and soybean plants enough to not cause trouble? Thanks for any help you may be able to offer on these questions.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.