Posted by jeffcat on May 18, 2015 at 09:45:45 from (73.197.157.130):
In Reply to: Re: The hum of spring posted by fixerupper on May 18, 2015 at 05:42:50:
I know that people jump up and down about Harbor freight but they have two good size units that can handle almost anything. The 7000watt running load unit my friend has. He loves it. Around $800.oo. They also have a beast at I think 11,ooo kw. That is still not too expensive at about $1700.oo? Don't get a small one, you want to be WELL prepaired! Generators today are about $100.oo per 1000 watts of power. Now to run a compairison I have a Win Power generator from 1956. It is in mint condition! It is rated at a constant load 2200 watt. It has a cast iron Briggs with copper core fields and is all cast mallible steel. I can just bearley pick this thing off the ground with my knees braced and only about 4 inches at that to get it on a pallet. In 1956 after a big hurricane my friends dad paid $447.oo for this little honey! Now back then you could buy a pretty nice used car for that much. Generators have gotten pretty cheap.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.