Posted by Donald Lehman on May 29, 2015 at 15:50:46 from (184.8.237.72):
In Reply to: Grinder Mixer posted by Mayfair on May 29, 2015 at 11:22:22:
As Randy said, make sure the grinder is running when you pour in the minerals. I would suggest grinding a portion of the grain into the mixer, then put in your minerals and other suppliments and then fill the grinder up. I think I still have a new auger for a 354. Don't know if it fits the 353, but if you do need an auger check the NH part #'s to see if they are the same. You can also remove the auger and weld new flites on the thing. It's a miserable job to remove the danged thing but we have done it and rebuilt augers. Don't know as I have ever seen a cover on a dust collector. Not for a NH anyway.
One other suggestion. Never, ever dump ingredients into the hopper without the screen down. If you get an old feed bag wound up in that auger you will 'bout go crazy trying get that thing unwound! Grinder/mixers were NOT designed to be mechanic friendly!!!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
