Posted by ss55 on May 31, 2015 at 11:12:42 from (173.16.23.173):
In Reply to: Re: LAWN MOWER posted by lenray on May 30, 2015 at 17:03:53:
I agree with Geo-TH, as much as possible landscape to eliminate the need to trim. We added hosta plants as borders around trees and buildings. They form a solid border that will stop most lawn grasses. The leaves overhang enough to give about four to six inches of leeway for mowers. They propagate quickly, divide them into four or six pieces at the spike stage in early spring.
Mulch also makes a great border if you don't mind adding more material every two or three years. That might be an easy way to start adding borders.
My experience with self propelled mowers is they are heavy and hard to maneuver in tight spaces, but they are easier to push up hills. On hills, rear wheel drive has better traction. For years we used a small Sears 20 inch mower for trimming and some mowing, it only weighed 70 pounds with a 4 HP Techumseh engine. I eventually wore out the cheap plastic wheels and put ball bearing wheels on the rear axle. Techumseh engines may not have a good reputation, but that one is over twenty years old with just reasonable maintenance.
I found some high wheeled mowers with the rear wheels far back were clumsy to maneuver because it is so hard to lift the front wheels to turn tightly. The high wheeled mowers with the rear wheels near the center of gravity were much handier. Before buying, have your wife pick the style she likes best by turning and twisting them around tight corners in a store.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.