Posted by oldtanker on June 08, 2015 at 20:50:37 from (64.118.3.19):
In Reply to: Bulldozer Rampage posted by Mark - IN. on June 08, 2015 at 16:13:06:
Quoting Removed, click Modern View to see
Same song different dance. That happened a 2nd time. The 2nd time the guy started across the Rhine and stopped on the bridge and surrendered. He too have received a deer John letter from his wife and went and got drunk. Then he decided, while drunk that he was stuck in Germany because of the Russians. He figured that if he went and started a fight with the Russians that we would win and then he could go home and save his marriage. He went home on a medevac flight strapped down to a litter and sedated. Was eventually given a "section 8" discharge. At the times of both incidents all tanks in Germany had a combat load of ammo on board.
As far as the firing pins in the arms room: I could go to the arms room on any day scheduled for vehicle maintenance and get my tanks firing pin. Part of operations checks and services was a check of the firing circuit and you needed the firing pin to do them. Tank ammo is electrically fired. The firing pin dents the primer only to establish good contact.
For those who don't know a combat loaded M60 tipped the scales at 60 tons and the A3 model was a hefty 63 tons. The M1 is about 70 tons. They do a little bit of damage when they run over a car. That WILL NOT buff right out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
