Posted by blue924.9 on June 10, 2015 at 19:29:36 from (184.63.108.133):
In Reply to: huffy mower posted by blue924.9 on June 09, 2015 at 20:09:47:
[quote="t.r.k."](quoted from post at 19:15:12 06/10/15) Its been a while since I converted a magneto to electronic trigger, but curiously, that was a 4 hp. on a Huffy. (The points were glazing over and had to be cleaned every time I wanted to run the mower. If your Huffy was like mine (Dad's) you have to remove the steering wheel and hood to get to the flywheel.
I am guessing your kit hast the trigger in the clear-mostly clear-plastic and it just snaps over the magneto. It goes on the left side of the coil looking down on it with the sparkplug at the front. You just basically cut the wire to the points, route it to the spring loaded hook on the trigger and you are in business. You can leave the points in there, otherwise you need to plug the plunger hole so it won't ooze oil.
One thing: I was thinking that you could buy the entire ignition module with the trigger built into it for about the same money that you coumoduleld buy one of those kits for.[/quote
I do believe it's the module, its clear and you can see the copper windings. The kit has the module, a metal key looking thing for a keyway and a wire with a loop end on it, the module also has an uninsulated wire on it. Plan on leaving points in so oil doesn't ooze oil and I will for sure need the hood off and I could see the wheel needing to come off as well. Thanks for the help the instructions confused me and I even work on mowers for a living lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
