Posted by Bill(Wis) on June 28, 2015 at 06:43:11 from (216.46.173.36):
In Reply to: Lawrence Welk? posted by larry@stinescorner on June 28, 2015 at 05:36:36:
"Ah one an ah two":(;>)) He was Dutch. It used to drive some of his musicians up a wall on how he would withhold some of their pay that would go into a special account that they could only draw from with his approval. He wanted to teach them to save money. Speaking of New Jersey, his sister used to own a farm up in Sussex County along Hwy 206 near Hainesville. It's still there with the beautiful old farm house and barns with white board fences all around. And, a little farther south, in the Ross' corners vicinity, are the old Tanis farms. Vic Tanis came over from Holland when he was 5 or 6 years old and bought his first 40 acre farm at the age of eleven and never stopped buying farms. By the time WWII (The Big One) came along, he had 1100 milking Guernseys with his own creamery with a rail siding running into it. He was the same with his employees (many of them young Dutch boys) in that he would also help them save money and when they became older they would have enough money saved to buy their own farm land. Some of the farmers up there with Dutch names are those boys and are not descended from the Dutch that originally settled the area some 300 years ago. In that they lived so close, he almost had to know L Welk's sister and perhaps "Larry" as well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.