Posted by JD Seller on June 28, 2015 at 16:04:12 from (208.126.198.123):
In Reply to: cylinder bars 8820 posted by stonerock on June 28, 2015 at 15:28:46:
IT all depends on what cylinder bars you have. 3/8s could be shot or could be fine. You can tell by looking at how even they are side to side the edges wear little compared to the center. As for your plugging the cylinder. That could be caused by many things: feeder house drum set wrong for the crop/header your running, cylinder speed wrong for the crop conditions, if your using a grain platform the auger extensions could be set wrong for a JD 8820 as most where used on smaller machines.
The long and short we need a little more information to tell you if the cylinder bars are the reason you had cylinder plugging. Crop and conditions you where harvesting in is one thing? What settings you where running at when harvesting? Also what type of cylinder bars you have, factory JD bars or after market ones???
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
