I don't live in a highly populated area but around here houses are burnt down all the time. Some guys will recover the cast iron from the ashes afterwards but that's about it. It'll cost you a couple of straw bales and a match to get it going and five gallons of diesel in your backhoe to bury it and your done with it.
Only you can decide what's right for your situation. Will the fire spread on your property to other buildings? Can it spread to the neighbors? Does your township or county have a burn ban? Do you have any trees nearby that you don't want to see dead within a year afterwards? Is there a specific direction the wind needs to be to burn without smoking out the neighbors? If your fire department won't burn it unless asbestos and asphalt are removed does that mean you can't burn it yourself? Meaning is this just a fire department policy, not necessarily a law you have to abide by? Most people here will call the local sheriffs office to report a controlled burn so people aren't freaking out when the smoke starts. If there's a chance the fire could get away they may also call the V.Fire Dept. just to give them a heads up and to be on call for a few hours just in case. Just remember that on the downwind side at full flame you won't be able to get within 50 yards of the house for the heat so do a walk around before hand and just know your not going to be able to put out grass, tree or building fires within that radius until the fire burns down. Figure about a half hour minimum that you won't be able to get close.
If you run into roadblocks on this, a nighttime thunderstorm is a good time to burn. Claim lightning strike and tell everyone to get over it. On the positive side, everything around will be wet and keep the fire from spreading and nobody can see the black smoke in the dark.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.