The trimmers provide some support for the header, but for the most part are just filler for your door opening. The header is supported on both sides by the basement wall so you can work on the trimmers one side at a time without having to support the header.
The trimmers may look worse than they are. That gray patina may be caused by weather but they look like repurposed forming material to me. Drill a small hole in the bottom of the trimmers one inch above the concrete base. They may be sound. If you don't like the idea of using penetrating epoxy to turn them into a block of resin, cut them out and replace them with new. A sawzall will remove them quickly. It's the going back that's a little harder and depends upon how the first trimmer is attached to your basement wall. If attached with foundation bolts, I'd leave the bolts and reuse them. If attached with a ram set then cut the nails and reattach with concrete drive screws.
I assume there's nothing on the inside covering the trimmers. If there is, then the job gets a little harder.
The more I look at your pictures, the more I see. That trimmer on the right against the basement wall looks pretty good. It's the 1x in the middle and the 2x holding your door frame that look damaged. If that damage is only an inch or so deep, just chisel it out and fill with epoxy before you cover it up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.