The cost per page printed is much lower with a laser printer. Inkjets are a complete PITA. If you don't use them frequently, they gum up and don't print. If you use them frequently, they cost you a fortune in ink.
Get a color laser. You will be glad you did.
Warning: the next scam you are going to run into is toners. Here is how it works... Printer is priced fairly modestly. Runs from about $200 or so to over $1000. A decent one will run in the $300 range.
The printer will come with what they call "starter" toners. They will print a predetermined number of pages and then give you a "low toner" or "out of toner" message. Printer may even refuse to print at that point. Cost of new toners from the store is prohibitive. Replacements for mine would have cost more than I paid for the printer.
BUT..... those "starter" toners are actually full and usable toners that have been "brain damaged" usually by the removal of a small timing gear (at least in the case of the Brother printer). This gear can be obtained on line for a small fraction of the cost of a toner. Aftermarket (third party) toners are also readily available on line. Refill kits that contain the missing parts to refill and convert the "starter" toners to full toners are also readily available. It took me about 5 years to use up my set of "starter" toners.
Once you have switched over to laser, your biggest cost per page will become the paper rather than the ink.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
