Posted by El Toro on July 12, 2015 at 11:29:12 from (74.103.50.151):
In Reply to: Re: MBT70 Tank posted by oldtanker on July 12, 2015 at 08:01:56:
I didn't get a good raise until I was asked to take over a Vibration Facilty. Chrysler hired a retired Colonel to open doors. Hal PS: I made 5 trips to Elk Grove Village IL on this vehicle and it had a problem with differentials over heating during the acceptance tests. We were told to lower level in the differentials and it didn't help. One day I happened to walk along the tires and they were hot. They had installed Goodyear nylon bias ply tires. Our management had requested these even though we requested Michelin radials. I called a Goodyear dealer in Baltimore and he wanted to know how fast we were running the vehicle. I told him around 45 mph, he said they had a max speed of 25 mph. He came up after I asked him to talk to my supervisors and we ordered Michelin tires and no more overheating.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
