Around here a lot of folks move round bales with a skid loader that way - lift the bale way up high to see under the bale.... Sure makes a top heavy rig, and easy to tip.
I sure understand getting by with what one has.
Is there a way to make the loader bucket curl back more, shorter ram or something, so you don't need to lift the load so high? It just seems there is something not right there, you should be able to scoop into the dirt and curl the bucket back to get a load in the back of the bucket, not need to lift it so high.
Aside from the risk of rolling over, it would save a whole lot of wear and tear on the reactor and hydraulics, not needing to strain to lift so high. And you could make less trips. Typically a bucket can curl more weight than the arms can lift, so you end up with more dirt closer to the back of the bucket, lifted less high.
Safer, easier, cheaper, less time....
It may be worth looking into that, even on an extreme budget. A different length bucket cylinder might make things just so much better, if it can curl back more but still dump out.
I took a gravity wagon load of corn to the elevator last fall the bolt in the wagon tongue - wagon side of the hitch - broke, that was real exciting stopping and I was nearly stopped to beignet with making a turn, the different ways that could have gone wrong.... This stuff happens, don't take the negative comments too hard, most of those commenting have done as bad or worse themselves, I know I have. Kinda like a reformed drinker or smoker can get a little preachy, I think we can get preachy on this stuff if we live through enough issues ourselves. ;). Thanks for posting.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.