First of all - credit cards allow for a lot more "impulse" buying than cash - and buying extra things that a person never really intended to purchase when they went to your store to buy a bolt. So don't put up a wall to keep that from happening. NEVER punish a person for wanting to spend more money than they have at your store!!! In fact, you PROBABLY sell more "extras" than you realize due to credit cards, and those sales probably already cover your 4% fee quite nicely.
Next - let's say 50% of your customers pay with credit cards (for simplicity). If you want to spread the cost of cc charges across to all, you don't have to raise your prices by 4%, you'd only have to raise them by 2% (50% of 4%). If only 25% use credit cards, you'd only have to raise them by 1% (25% of 4%). So that doesn't avoid the problem altogether, but it certainly may reduce it to a point where it's more attractive to you. Of course, if over 90% of your customers use cc's then you do have to raise by 4% - but ... by default you'd have to do that anyways.
If you feel you must raise the prices for cc usage, do as somebody else here posted and call it a DISCOUNT for paying with cash. It's the same thing - but mind games work. Again I have to stress it - you never want to persuade somebody NOT to spend money they don't have in your store - a credit card is a wallet full of imaginary cash. (and don't forget to surround your register with "last minute" impulse buy items. :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.