I'm tellin ya, LOL ! it just takes the work right out of it. The area in the photos that is clear, just mulch I left for future plantings. Today I'll uncover it and plant mostly greens that will be just right when the rest of the crops are ripe. Might even put in a 2nd crop of cukes, as I really like those daily in the salad.
Dry it like you would quality hay, but if its a little moist and green, its fine. Only reason I don't haul it in wet is that its too heavy on the lawn tractor and sweep, so much easier dry and it does not turn to mush like wet clippings will underfoot.
No weeds to speak of here and its been down 1 month, + it does have a good amount of nitrogen. I've piled it up it near stalks of corn, and those plants were the best in the patch, or that side which seriously lacked in soil quality 2 ears per, forget what type of corn it was, might have been silver queen, was the longest duration in the entire patch as I put that in the back rows so as not to shade the other varieties.
I don't know if when the grass mulch molds, if that causes powder mold on cukes. I just spotted it on the peonies further over in the yard, those I will cut back or spray or something. as its sure to get onto my cuke patch trellised on the fence that keeps the deer out. I could have those all season, but this mold does seem to do them in sometimes. In my opinion, grass mulch is the best weed control I can think of with extra benefits, at least in these parts it is.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
