Posted by tvscum on July 23, 2015 at 20:36:28 from (66.75.55.78):
In Reply to: 1926 Gotfredson posted by tvscum on July 23, 2015 at 00:25:11:
Thanks for the replies! I will check out the Allis section. It looks like the truck was restored and re-wired with aftermarket knobs, gas primer, etc over the years. That brake fluid can is now serving as the gas tank apparently.
Again, I have not started it yet because it has no spark and the magneto is getting rebuilt.
Anyway, the generator definitely does not have a Field terminal so I can't adjust generator output using a lighting switch resistor, I guess. I took the generator apart and the adjustment of the third brush seems pretty simple.
This post was edited by tvscum at 22:34:28 07/23/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
