I have a Mahindra Maxx25. Steel hood and fenders. Good solid castings. bought it new June 2013 paid 16500 with FEL and Mid Mount mower. Hydrostatic with hi and low range. Hi range is pretty much useless except for mowing and transport. Low range is a tough workhorse. With the deck on the lack of clearance renders the tractor pretty much useless for any purpose off the lawn. Deck is drive over but you still don't want to change it unless you have to. You need to be aware that on some SCUTs you must turn your cat 1 3pt pins to face each other. Mahindra is wide enough to work normally. Mine was built in Japan, uses a 3 cylinder Mitsubishi engine. Tires wheels are Titan, Made in USA, attachments are also American made. I hava a bit over 200 hours and so far zero problem, I did a serious clean up under a barn that had many years of build up in the calf pen. probably 3 ft deep in places. Surprised the hell out of me, under that garden tractor exterior lives a serious working machine!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.