Posted by MikinInd on July 31, 2015 at 12:34:45 from (71.228.33.22):
I recently discovered that splines on my model A's crankshaft were pretty bad on the pulley end. I found and purchased decent looking used one to replace it on ebay and just received it yesterday. I was somewhat dismayed to find that one of the splines was partially missing as shown in the pics. It was described as having good splines and this was not shown in any of the pictures on the auction. I thought that it might have gotten chipped during shipping but there was no evidence on the package to indicate that. Upon a closer look there are machining marks like someone purposely milled this off at some point. Why would they need to do that?
Will this need to be repaired? All of the other splines and what's left of the one look really good. I don't plan on working this tractor hard but I also don't want any problems down the road either.
I'm still pretty disappointed that this wasn't disclosed in the auction to begin with. The seller has 100% positive feedback so I thought he would be trustworthy.
I'm no expert on this old tractors so I would appreciate hearing opinions from more experienced folks.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.