Posted by bison on July 31, 2015 at 16:21:38 from (69.168.144.139):
In Reply to: Field Fence mending posted by Lamont in NC on July 31, 2015 at 13:04:03:
Quoting Removed, click Modern View to seeIf these small trees like that in your pic flatten the fence to the ground then the fence was not nearly tight enough.
I stretch my bison fence tight to the point of spinning out with the tractor pulling on it before wrapping and stapling it to a corner post/brace.
most trees that fall on it don't do any damage. It takes a 12-18" dia tree to lay the fence on the ground, there is often enough give in the wires that most but the top two or 3 wires spring right back after the tree is cut free of the fence.
If these wires are to loose i cut them, stretch them individually tight and put a crimp splice or 2 on them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
