Posted by Adirondack case guy on August 10, 2015 at 18:08:18 from (74.69.160.79):
Well, I made it through my 44 daily cancer treatments with flying colors. Finished last one July 8th., and all geared up to start cutting my 2015 supply of firewood. A few days after that I developed sever angina and had two stents installed. Felt better for a couple days and then all heck broke loose. Back into the hospital and all kinds of scans etc. They found nothing further that needed imediate attention. The docs changed my meds around, but wasn't helping much. Still haveing angina attacks, and needing nito pills. Went to keeping an hourly log of my BP, activities and diet. Got an appointment with a NP and I think she is smarter than the docs. She told me to adjust my BP meds on the fly so-to-speak. I ame takeing a quick release with my other prescribed one in the morning after coffee, and another at noon. That is working. I also discovered that Pepsi was causing an instant rise in BP. Stopped drinking that. Also discovered that a couple barley pops at the end of the day dropped the pressure also. I have spent the last 3 days up in the woods opening up another section of woods. Built this road, and cut down all the dead and distressed trees, and cleaning up all the downers that were worth saveing. I have a bit over 2 full cord of wood at two landings ready to be blocked, split, loaded and brought home and stacked in the woodshed. Pics are of the 3pt skiding arch that I built for my B2150 Kubota. It is working out very well. I can drag the winch cable back into the woods 35' while the tractor is parked out near the road. Leaves minimal impact back off the road, and I don't have to worry about a stray stick doing damage to the tractor. The winch is a $54 HF 2500# with remote. Real handy setup. I just walk in and hand carry any good limb wood laying back off the road and block it, and load it into the tractor bucket. I made the road wide enough for PUs and my cab tractors to get through to get to the 80A wood lot on the other side of the corn. We used to just drive in the fields around this little woods, BUT since I pushed all the brush back around the edges, and cut all the overhanging tree limbs last fall, this year the uncles planted corn rite to the trees, and it all grew tall, so I would have been in deep dew if I ran down a half mile of corn to get to the back woods. Loren, the Acg.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
