Posted by Steve@Advance on August 14, 2015 at 16:21:34 from (107.203.134.67):
In Reply to: Cross bearing help posted by mattcatlin on August 14, 2015 at 15:29:55:
As others said, take it back apart and check for needles laying down. Then lightly squeeze the cups on the cross in a vice to compress the seals. Take some measurements to be sure it's the correct part.
Then, remove the grease fitting to get it out of the way. Remove all the cups, pack with grease to hold the needles.
Here's the tricky part! Place the empty cross in the yoke. Push it all the way to one side, slip the first cup on the cross journal that is sticking out the yoke. Place the yoke in the vice and squeeze the cup in while keeping the cross journal firmly inserted in the cup to keep the needles in place. Then loosen the vice, put a spacer (a magnet works best) on top of the cup and continue pushing it in, past the snap ring groove, push it all the way in until the cross hits the other vice jaw. Put the snap ring on that cup.
Then carefully start the opposite cup in, be sure the needles are standing straight, push it in with the vice and spacer. Push it until the snap ring seats on the first cup. The snap ring can then be installed on the second cup.
Repeat for the other 2 cups. If it feels stiff, wack the yoke with a hammer on all 4 sides to firmly seat the snap rings and center the joint. Don't forget the grease fitting.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
