Posted by mtf on August 14, 2015 at 18:25:36 from (173.240.134.127):
In Reply to: Re: Cross bearing help posted by mattcatlin on August 14, 2015 at 17:51:14:
It is hard to tell, but it kind of looks like the side next to the nut is not seating properly, that will be the side with the bearing out of place. Removing is difficult. Drive both cups to one side as far as they will go, with large hammer and an impact socket. The part of the cup that sticks out past the yolk can be clamped in a GOOD vise with GOOD jaws and removed by rotating and prying. You will more than likely destroy it. I would replace it with a new one. Looks like a 35 series joint. I just bought some Made in USA for 35.00 last week. When you get it back apart measure to make sure cross is right size. I like to install joint in the 'heaviest' side first and easiest yolk side last. Some of these with cv's can be quit heavy and prone to finger pinching.
Also if you pressed with that much force you have distorted the bearing and put a flat side one it. Another reason to replace with new.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
