Posted by Texasmark1 on August 15, 2015 at 04:50:59 from (198.45.234.19):
In Reply to: VALTRA TRACTORS posted by BILLSCHAFFAER on August 13, 2015 at 20:19:46:
On parts support, I have a Branson and they are not well known. Dealers are only about 200 in the US. A lot of dealers just mix the smaller ones in with other lawn care products and they are not their main money channel. Nearest dealer that handles the larger ones is 50 miles away. Parts source is Korea but they have warehouses in TX. GA. and may still have one in CA..
So I'm mowing one day and a rock hits my cab door and being safety glass it shatters into a thousand pieces. Call the dealer mentioned and they said they have 7 in a warehouse in Plainview, TX. Bought one and with no special charge, UPS had it at my house in 3 days.
I figure if a remote dealer can get a part like that to you in 3 days with no super shipping charge, why worry about one being around the corner?
Besides, when I buy a tractor, I don't want one that's in bed with a repair facility!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
