Posted by NCWayne on August 21, 2015 at 19:37:31 from (173.188.169.54):
In Reply to: Welding Question posted by FBH44 on August 21, 2015 at 03:17:22:
One thing I haven't seen mentioned yet is to use one of the gold coated lenses instead of the green lens. I am somewhat color blind, with my problems being with the reds and greens, and there are many other guys out there with the same problem that don't know it if they have never been tested. When I started welding I couldn't see squat with a standard #9 green lens. Someone suggested trying the gold plated ones, and I have never used anything else. It changes the color of the weld puddle and, at least for me, makes a world of difference in how well I can see what I am doing with the same shade lens.
I had a buddy that was learning to weld, and he was having problems seeing the joints. He was using a moderately priced QC lens in his helmet, and I used it a couple of times just to show him the way to do certain things. I was able to weld because I knew what I was doing, even though I couldn't see as well as I wanted. When he asked me to fill in a gap, I had to get my helmet off the truck. When I was done I let him try it, and I just about didn't get it back. Like me, he said there was a world of difference in how well he could see what he was doing.
Too, as others have said, a clean cover lens both inside and out, makes a world of difference, regardless of what shade lens you are using. When one gets dirty the scratches will reflect the light and make you feel like your welding in a fog. You'll notice a BIG difference in how well you can see just by changing one, or both, of them, if that's your problem.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
