An accumulator is used for many things beyond just loader dampening circuits, etc. The size, shape, and pressure rating can vary tremendously depending on exactly what your doing with it.
An accumulator that size, bought for a generic purpose, is probably going to run you anywhere from $300 to $600 from a retailer. I used to get some 'special' ones that went on the top of hydraulic hammers that ran nearly $800 from the dealer, and were 'proprietary' so they weren't available elsewhere. That is to say they weren't available under that part number. My local hydraulic shop found the maker was more than happy to supply them brand new, to the same specs, as long as they were special ordered that way, with a new part number, as opposed to the part number on the other ones. That cut my cost on them by nearly half.
That being said, there is nothing really special in that setup, that I can see, except for maybe the mounting bracket. That being the case I'd ask maybe $300 for the whole deal, provided the diaphragm in the accumulator is still in good shape. Unfortunately the only way to really test it is to have the tools needed to charge it, and insure it is still charged to spec, and holding that charge. IF it won't hold a charge, then it's nothing but scrap (except for the valve and fittings), unless the diaphragm can be replaced, which doesn't look possible on that particular one. Hope this helps.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.