I hate to disturb those who are purist, But I found the best way to prolong the life of ignition parts is to add an electronic ignition. I know this is not exactly what you wanted, but its all I can help with.
They don't have to be totally electronic. The ones I use are point triggered. The points carry far less current than with a regular point, condenser, coil set up. I salvaged some from recycling yards and some are available on line and are also available from YT.
My first electronic ignitions were all CD types, Archer, Delta, Tiger.
When theses were no longer available I switched to hybrid units from 70s Toyotas. Some Datsun, Nissans used them. It is my understanding that the Chryslyer- Dodge units from this era will also trigger from points and don't need a reluctor. They are the ones that hang on the firewall and have the top of a large transistor sticking out (I just read this, and I don't really know they will work).
Two things I know for sure from experience.
1. The CD units I put on cars made the points last a long time.
I put one on my sisters Datsun 210 lasted 70,000 miles and
What finally failed was the point flat spring which broke from
fatigue. (it happened on the interstate, but luckily a knowledgeable good samaritan found the new set I had left in the glove compartment and put them in.
2. When I put a hybrid set in a Super C and had to hand crank it the engine practically started itself. The starter ring gear and pinion were worn.
I also make sure to use a moly high temp grease on the distributor lobes.
I don't know the best source of american or japanese ignition parts if they are still available.
This post was edited by Deutz Lover at 21:19:43 09/07/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
