Posted by Billy NY on September 07, 2015 at 06:03:49 from (104.228.35.235):
In Reply to: Re: Work on Sunday posted by buickanddeere on September 06, 2015 at 20:00:09:
Those suckers are usually in a little deeper than you may think, I'd be wary of returning to the site unless I saw the paper nest burn.
I got lit up like that about a year ago, did not see this hole in the base of the stump of a small tree I was cutting. I was standing on the nest opening, had denim jeans on, and knee high cotton tube socks, the little #@%$!'s could not sting through it, that kept the sting count down, and I lost count after 2 dozen elsewhere. No allergies to these or much else in general, I was then about as angry as they, picking the remaining clinging ones off my clothing, batting away the remnants of their aerial assault as I retrieved my still running chainsaw, now smoking from loading up at an idle! I took the loader bucket and re-arranged their furniture a bit, the next day, the pheromone was still on my gloves, as soon as I got near that nest again, 2 landed on my glove with bad intent. I finally up ended that stump and exposed the nest, did not care if they got me again, that nest was coming out! Nature did the rest and I will not to forget to look over any tree I cut again. They usually like a dirt exposed bank, along a ditch or the dead furrow wall, but now I realize small decaying or damaged trees area also places they nest.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
