Posted by 47fivewindow on September 11, 2015 at 12:02:02 from (50.153.185.56):
In Reply to: 9-11 where were you? posted by 37Chief on September 11, 2015 at 10:35:08:
I was on a high rise in Alexandria Va. I had heard on the radio a plane had hit the tower and wondered how that could happen on such a beautiful clear day. No information was yet known so i went up 20 floors to the roof to access the elevator room. As I crossed the rooftop I heard the explosion of the plane hitting the pentagon. two booms. Then the smoke from the north. I feared Washington was being bombed somehow. I found the engineer and we went back to his apartment to watch the news. My company had been working in the wing that was hit replacing the elevators and escalators. we were finished, but inspections were scheduled for 9/12. Our crews were sent elsewhere and the wing was to remain empty until our work was finale approved. That is why so few were lost in the destroyed wing. Most of the dead were on the plane. It burned for over a week. Chip Carr
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
