Posted by jeffcat on September 20, 2015 at 16:17:14 from (75.151.154.114):
In Reply to: Gravely 8123 lawntractor posted by claude.marthers@gmail.com on September 20, 2015 at 14:53:57:
If you are lucky.....the PTO has a 1/4 dia. pin in it. Take your mower off and take a look at things in there. It is dirt simple. As you rotate the leaver you will see that the "dog" should move in and out about 3/8 of an inch. If not take out the two bolts and see what is broken. What happens is people take out that engage lever and they drop the little block into the front casting. You most likely will find it laying in the gunk in the bottom in front of your nose. There should be one!!! Because if there is not one the 1/4 hardened pin gets ground off and now you need to replace that. I used a 1/4 drill bit to make a new one then put everything back together with that little block that rides in the groove around the engagemnet dog. While you are at it, check the teeth on the dog. They should be nice and square with no rounded edges where they engage. Also take a look at the clutch on your mower. The Ramps should be in the shape of little triangles with a nice sharp end and not all ground down. Have done several machines. Have fun.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
