Posted by Dave Sherburne, NY on September 22, 2015 at 19:01:24 from (74.32.156.24):
Man, there are a lot of apples this year.. wife and I and 3 granddaughters picked apples from a friends 6 trees. Then I called a family from the church and asked them to come make some cider with us. They have 3 adopted kids and 2 of their own. Well anyway we got out the cider press set it up and these kids thought it was fascinating. I made this cider press about 3 years ago and this is the first time we've really had enough apples to use it. The grinder is a 5" diameter laminated piece of wood that I rough cut on the table saw, them mounted it on the press and turned it round and built the box around it. We load it thru a 4" hole in a board on the top which keeps the apples from jumping back out when it's spinning. I use a 1/2" drill to turn the drum, it's 40 years old so it doesn't over heat. Ernie at the feed mill gave me 3 new 50lb. bags that we put in the drums to contain the pumice. The drums have metal bands that came around bundles of lumber to hold them together. After grinding the apples the 2" thick disk goes on the apples with some 2" blocking spacers then turn the screw and really get on it.We get about 3 gallons from each press. I started with just the 1/2" spout but soon found out it wasn't enough. The channel iron frame and screw came from a cider press I bought at an auction. The wooden frame on that one was well rotted.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.