Posted by Leroy on September 25, 2015 at 20:22:27 from (69.88.202.68):
Got up to acident seen today. I had not realized how close I came to having to be cut out of the truck. I went straight sideways about 15' into the pole. The truck is a V sideways as well as up and down with the point of the V down. About 20" farther back with the truck would have put the pole into my drivers side door. If it wasn't for the pole I probably would have been rolled over. The left tires when hit turf at edge of pavment cut a grove about 3" deep from sliding sideways. I got a cracked rib and a few other bruses. Way luckier than the passengers in the car, Driver 19 year old male ejected and passenger 17 year old female also ejected, both listed as incapaciting ingerys, Neighbor said they think she was run over with the car on right side of her body, after things could not see with right eye and her hair was found in the cars tire. Driver was sited for stop sign. Third person in car was a 16 year old male that evidently did not get hurt as he was not taken to hospital. All 3 different names and addresses. Car was owned by drivers Dad and was a 2007 Saab. Insurance adjuster was out today to look at truck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
