Posted by hrross on September 29, 2015 at 22:15:43 from (107.77.85.86):
In Reply to: Roundabout posted by Geo-TH,In on September 29, 2015 at 15:42:06:
you guys are really behind the times. here at oshkosh wis we have numerous roundabouts. most are on the roads over interstate 41. on three different roads over and onto 41 we have to go thru 4 roundabouts to get to other side. 2 are multiple lane with on off lanes to 41 or over to other side. really confusing if you dont know where you are going. roundabouts are all right if there is little traffic you go right thru, heavy traffic you sit there waiting to go thru. they tell us they are safer, less t-bone accidents, more fenderbenders. dont know how we got all the roundabouts. where hwy 21 comes into oshkosh, the plan is for 3 more. thats 7 just to go over 41! went to the hwy 21 meeting, they call it the 21 expressway, i told them it aint a expressway with 7 roundabouts. can you imagine stopping and going thru 7 roundabouts with a semi?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
