Posted by Billy NY on October 03, 2015 at 10:53:09 from (104.228.35.235):
In Reply to: Jd dealer sales staff posted by NEIADan on October 02, 2015 at 17:50:17:
They're pretty good here, expensive mind you, but they are located in the middle of a large agricultural community/area, not far from the CNH dealer. I see all kinds of older JD tractors and equipment in their shop for repair. The farmer I used to help for many years, dealt with them, work was always done right, but you paid. He, towards the end of his career, had new equipment and some older JD tractors and equipment as well.
The CNH dealer, shop rate is expensive, but they will work on anything. The service manager, a partner in the company, is very fair and extremely helpful, so are all there technicians/mechanics. Parts counter is very good as well, especially with older Ford tractors, if they can help you, they will on parts. Sales, in one year, we have bought 2 thru them, pretty decent, not new, but 15 & 18 year old tractors, they've were quite fair, though I have a different opinion of how they handle a consignment, they'd win hands down over the JD dealer, who is connected with several locations with one store name. Both are good because of the local market, they'd be out of business if they were not. Same area is a top notch independent shop, they're always busy, a bit less expensive, but work on anything, complete tear down if needed. We can't complain too much about what we have here as I see it, maybe someone else sees it different.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
