Posted by jimg.allentown on October 08, 2015 at 16:33:14 from (173.49.143.208):
In Reply to: IAGary and all posted by KEH on October 08, 2015 at 09:20:03:
Why do people drive around barricades?? Here are a few reasons...... Around where I live, they go overboard closing streets and blocking off main roads. I have seen them close a road for just an inch of water. And, this was after the rain had stopped and there was no further danger of flooding. Then there are the ones that just want to get HOME after a long day at whatever they do all day. Now, when the route is blocked, they turn around and take another route only to find that one also blocked. Frustration sets in and finally, they go around a barrier. Most times (at least around here) there is no problem with doing that. Worst case is usually a stalled car or getting stuck in a pothole that they did not see. Most of the time, the potential danger is disregarded something like in the little boy who cried WOLF!!! After a while, you see a barricade in a spot that you travel often, and KNOW that the water cannot be over a couple of inches deep, and just go for it.
As for myself, if I see running or rapid water, I find another route. If I see water flowing over a small bridge, I do not try to cross it. In any case, if I do not KNOW how deep the water is, I find another route.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
