Over each of the past several centuries, including the last one, sea levels rose by about 7 inches (18 cm).
Accordingly, neither the overall warming trend or sea level rise began with the fossil-burning Industrial Revolution… nor have they changed in any detectable way due to human influences. And we can’t even really know that the second follows the first. Sea levels rose during the Little Ice Age from about 1400-1859 AD… a period which was considerably colder than now.
Unlike floating sea ice (the Artic) which doesn’t influence sea level when it melts, the West Antarctic Ice Sheet is part of the land mass. When it melts, it adds to sea level just as melting glaciers do. The end of the last Ice Age 18,000 years ago caused the sea level to rise by a huge amount…about 400 feet. This change happened rapidly at first, caused primarily by the melting of huge ice sheets covering North America and Eurasian land masses which disappeared about 8000-5000 years ago.
The West Antarctic Ice sheet began to melt at that time also, but at a much slower rate, and that melting continues today. We might expect this melting to continue until it is gone in another 7,000 years or so… or until the next Ice Age, whichever comes first.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.