In my career we always applied ant-seize to all fasteners on the WESTINGHOUSE STEAM TURBINES and WESTINNGHOUSE W92 Gas Turbine fasteners on the "Case Split Lines". These fasteners ran greater than 1500 deg F. Also the HEAD BOLTS on the 4000 HP NORDEBERG,2000 HP & 4000 HP Ingersoll Rand, as well as the 9000 HP Clark/Dresser Rand units. All HEADBOLTS,STUDDS and NUTS that required a Specific TORQUE were lubed with ANTI SIZE. Most all head bolts were torqued to 100FT LBS and then a HYDRAULIC JACK was attached to the THTREADS protruding through the NUT. The HEAD STUDDS were then stretched until all JACKS/RAMS read 10,000 PSI . At that point all NUTS were ran down until they came in contact with the head or the machined BOSS on the head. There was a Girdle that held as many RAMS as there were HEAD BOLTS so as all STUDDS were stretched the same amount at the same time. Bob...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
