Posted by Billy NY on October 16, 2015 at 12:45:09 from (104.228.35.235):
In Reply to: Ford 861 or 4000? posted by old-ford-fan on October 16, 2015 at 07:59:23:
Problem with some of these, they can be made up of other tractors of the '55-'64 production run, but at least you can date the serial number off the flat spot on the starter, and potentially the casting numbers on the main housings.
Haven't we seen posts on that on the ford forum here, someone will post casting numbers instead of whats on the flat spot by the starter?
Diamonds preceding and following the tractor serial number are supposed to mean a sleeved engine block. On the flat spot of the starter it reads the model number "850", then the serial number preceded by and followed by diamonds. It has flat running boards per a 1955 model. If its the original sleeved block, then I know its either correct period or the actual engine it was built with, so the engine and transmission are what it left the factory with. I would assume the hydraulic and differential housings would have casting numbers that could be deciphered.
Very possible to have another engine in it or its pieced together, some of these have been given the age now.
Its not like these are matching number collectible 60's muscle cars, so the importance may just be a curiosity/novelty, but, for example older caterpillar main housing casting numbers can be deciphered, seems reasonable ford had their own system or one like it. Just throwing that out there, someone here may already have the means or information to do this, seems I've seen it before here or somewhere.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.