Posted by sparepartsTN on October 17, 2015 at 23:38:38 from (98.87.31.45):
In Reply to: Re: Ford 861 or 4000? posted by old-ford-fan on October 17, 2015 at 19:21:45:
You must have a real Ford, needs repair already! ;-)
It is 1 am here so just a quick note. The starter switch on the transmission can be tested by putting a test lead from a meter or test light to a positive source and the other lead to the connection on the front of the push button switch, all the push button does is provide ground to activate the solenoid, providing the transmission is in neutral. I should have asked if yours is 6 or 12 volt, positive or negative ground? Anyway the fine people who provide this site sell parts and manuals to help support our habit. If you go to the top of the page and click on Ford at the top right, then 801, then electrical system, you will find a key switch near the top and a starter solenoid about half way down. Lots of other useful stuff on here. If you haven't bought manuals yet I can provide a basic wiring diagram to get you started. The big Ford Tractor Shop Manual 1955-1960 that they sell here has proven very useful to me. The starter solenoid for use with the original starter push button has 4 posts, the one on your tractor may only have 3 with the key switch. Electrical is not my forte but I stumble through with help from the manuals. One more thing, the Ford board down below is where a lot of the mechanically minded Ford people hang around, you may want to pick their brains also. I prefer to troubleshoot and repair than throw parts at it and hope, I think it is cheaper. I will give some thought to your troubles tomorrow. Oh, the carb is simple, disassemble soak in a carb cleaning solution can from your favorite auto parts store and re-assemble with a kit from YT.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.