Posted by Suffolk1 on October 20, 2015 at 06:46:00 from (72.173.142.144):
Considering other ways to stack twine tied round bales (4 X 5) inside an open-sided shed. Currently use a hay spear attached to the loader bucket (7ft. wide) on a backhoe and place the bales on their side in a pyramid stack. Using this method, you effectively only use one half of the volume available inside the shed. Also any unused bales get buried at the back of the stack when next years crop is placed in the shed. It is not possible to remove one "row" of bales from the front to the back of the shed, so that the unused bales could be fed up first the next year. In my travels, I have seen round bales stacked on their flat ends, two to three bales high, to fill an open sided hay shed. It appears this method would allow removal of one or two "rows" of the bales clear to the back of the shed and the surplus hay bales from one year could be fed first the following year. The bales would not be stacked in a pyramid and the full volume of the hay shed would be used. This would allow a much larger number of bales to be stored under cover without increasing the size of the shed. My questions are: (1) What type of spears, grapple, squeeze, etc. is used to rotate the bales and stack them on their ends two or three high? (2) Would it make any difference if the bales were mesh wrapped? (3) Do the bales compress much when stacked vertically on their ends three high? (Could see a house of cards toppling if they did.) (4) Got any personal experiences stacking this way or other suggestions of how to stack? (5) Got any pictures? Thanks for any suggestions or clever "farmer fixed" ideas.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
