Posted by kopeck on October 20, 2015 at 10:07:59 from (65.18.100.4):
In Reply to: PTO Generator Drives posted by Traditional Farmer on October 20, 2015 at 05:30:11:
The only time I ran my WINCO I did it with my super M and I wasn't to thrilled with the performance but I think that was user error. The voltage jumped around A LOT, so much that I could see lights flickering and this with almost no load.
I talked to the support guys and they said that these things are super sensitive to PTO shaft alignment. Since mine is on a cart (I wanted to use it on non-3pt tractors) the PTO shaft was going up hill, not at a rate that would bother any farm equipment but I guess enough to bother the generator.
Oh and if you go WINCO and are thinking about a cart build your own. The one they sell is a HUGE rip off. It works but it way over priced.
I went WINCO to get a US company, when I got it home I found out the head was made in Italy...Go figure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
