It will be 10.5 feet working width. That is the frame size they used on all of the field cultivators and for wider they just used extensions. And with the springs as they are it will not penetrate into hard ground, You have to let it go as deep as it will then try crossing and do same way. Crossing will give a chance for the shovels to catch in bottom of grove the shovels made first time over. and make it go deeper. Going same way for second time the shovels will just find the grove from the first time and follow them. That 88 is about same power as the late 4000 Ford and I pulled one over many a acre with it. I actually had the extensions on mine to make it cover 13.5 ft. And I aldo did pull it with my John Deere A that compairs to the Oliver 77. The Ford version made by Glenco and that is what I had has a better designed spring system for down pressure than the one sold under the Glenco name. There was also a version sold under the Case name. I did also have the 3 point version for a time in 15.5 feet but the extensions came of both shortly as that way could get around better and also the spike tooth harrow fit behind better.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
