Posted by 37Chief on October 31, 2015 at 11:05:52 from (70.181.181.228):
In Reply to: Mechanical skils posted by Dan in Ohio on October 31, 2015 at 09:21:37:
Growing up on Dad's farm I learned how to use wrenches. I would like to take tings apart, soon I was able to put them back together. I learned a lot about motors from my 48 Cushman scooter. Taking the motor apart and putting it back together, and it actually ran after that. Then to cars, my 34 Chevy I did the same thing. All my working time which was around 45 years as a maintenance mechanic in factories. I was around machinists a lot also, and learned a lot from them using lathes, and mills. I was a aircraft mechanic in the Navy, about all I learned was there was how to tie safety wire, and stand watches. At 73 I do all the work on my tractors,and motorcycles, except for any machining work. I stay away from the new vehicles with all the electronic stuff. That's about it. Stan
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
